by Al Myers
(The following are the USAWA Rules for the Full and Half Gardner Lifts, taken from the USAWA Rulebook)
D11. Gardner – Full
The first part of this lift is to perform a Half Gardner according to the rules of the Gardner – Half. Once in the finished position on the platform of the Half Gardner, an official will give the command to rise. The lifter must not rise before the command or it will be a disqualification. The rules of the Gardner –Half apply to the rise as well. Once the lifter is standing upright, with the bar motionless at arm’s length overhead, the feet parallel and in line with the torso, an official will give a command to lower the bar. The bar may be in any degree of rotation when overhead. The bar must be returned to the platform under control by the lifter to complete the lift. It is acceptable to use both hands to lower the bar.
D12. Gardner – Half
The lifter may put the bar overhead into the starting position by any method, except upending the bar. This may be done using a One-Arm Clean and Jerk, One-Arm Snatch, pushing the bar overhead in one hand using both hands, putting the bar overhead with two hands and then moving it to one hand, etc. The bar is gripped in the center. The start position is when the bar is held motionless overhead with a straight arm, the lifter’s body upright with legs straight, and the feet parallel and in line with the torso. The non-lifting hand must be free from the body. Once in this position, an official will give a command to start the lift. The lifter will then lower the body to a lying position on the lifters back on the platform by any method, ending with the bar held at arm’s length overhead. The lifting arm must remain straight throughout the entire lift. When the lifter is in the lying position on the platform, the shoulders, legs, hips, head and non-lifting arm must all be in contact with the platform. The bar or plates must not make contact with the platform during the lift. The bar must be under control at all times. The non-lifting hand may be placed on the platform for support during the lift. The bar is allowed to have a slight tilt to it during the lift, as long as the lifter has the bar under control. The bar is allowed to rotate during the lift and may be in any degree of rotation when the lift is complete. Once the lifter is in the proper position lying on the platform, with the lifting arm straight and the bar motionless, an official will give a command to end the lift. The lifter may use both hands to lower the bar or spotters may assist in removing the bar.